Designed to change tools in just seconds.
Draws tool holders into the spindle taper & throws them accurately & consistently at the touch of a button.
Automatic and Mechanical PowerLock Drawbars
Available for most manual & CNC mills with standard R-8
collets or 30 or 40 taper tool holders.
Automate your present
Knee-Type milling machines by installing a Kurt PowerLock
PowerLock Drawbars reduce tool change time and
allow more cutting time in the cycle. This eliminates waste.
whole process using the Kurt automatic or mechanical
PowerLock Drawbar cuts the tool change time to one-fourth
the time required to change tools manually with wrenches.
added benefit is consistent torque on the drawbar rod. When
you multiply the time savings for every tool change on all of
your mills, it can really add up.
Easy installation - operator can install with no special tools
Reduces operator fatigue - improves productivity and safety.
Eliminates drawbar tapping to free tool in collet - reduces
Convenient control - eliminates operator stretching to reach
Assures uniform collet tightening - prevents under tightening
and tool slip or over tightening and drawbar breakage.
Operates on shop air supply - filter/lubricator, regulator and
gauge included with most units.
Provides clean oiled air to
ensure long life.
Safety interlock on automatic models prevents accidental
Used with present tooling - operates R-8, #30 & #40 taper
Additional special tool holders not needed.
Available for R-8 collets,
#30 or #40 taper tool holders.
Operates on standard 80 PSI, 3 CFM air supply
Safety interlock to prevent accidental engagement
Drawbar, tailored to fit your machine
Pneumatic tool change system with air filter & lubricator, regulator & gage unit
All mounting hardware
1 Year Warranty